System Test
Testing conducted on a complete, integrated system to evaluate the system's compliance with its specified requirements .
See Also: Systems, Equipment, Test Systems, System Integrators
-
product
High Voltage Breakdown Test Sets
HT-Series
Dielectric Voltage Withstand Test or High Potential Test (HIPOT test) is a 100% production line test to verify the quality & electrical safety characteristics of products.
-
product
Space-Magnetic Field Visualization System
EPS-02EMF System
The system detects position of the magnetic field sensor on the basis of the image on the camera first of all and then, recognizes strength of the signal that is measured by the sensor upon frequency analysis of the signal almost simultaneously. Finally, visualization of the strength dispersion in composition with the real image of the measured object can be realized on screen of PC.
-
product
Cable Fault, Test And Diagnostics
Allows an operator to test twisted pair cables for faults without physically disconnecting the cables from the switch.
-
product
Switching Test Set
U3020AS26
The Keysight U3020AS26 is a switch matrix that consists of two single-pole-six-throw (SP6T) switches. It allows switching of multiple signal paths without physically changing the connections. This allows multiple tests to be performed with the same setup, eliminating the need for frequent connects and disconnects. An entire testing process can be automated, increasing the throughput in high-volume production environments.
-
product
6 MHz Level Test Set ET 92
ET 92
100 Hz to 6 MHz selective/wideband Level Meter & Generator, with Spectrum Analyser
-
product
Noise Monitoring System
NoiseTutor
Continuous monitoring of environmental data in remote areas has always presented a unique set of challenges. Typical solutions involve complex installations, frequent visits to remote locations to keep the system fully operational and require expert level attention to retrieve and share data amongst customers, consultants and project leads.
-
product
Gas Monitor System
Henan Bosean Electronic CO.,Ltd.
Used to detect combustible, flammable and toxic gases, and oxygen depletion.
-
product
Inline Planer Moisture System
MC Pro 2500
Maximize grade recovery with SCSFP’s highly accurate lineal planer meter. A full moisture map of each piece ensures you are properly tracking moisture content at the planer. The system easily couples with lineal auto graders for moisture content handoff. Integration via ProTrac software, with barcode or manual tracking, provides advanced kiln analysis and drying reports.
-
product
500 HP Complete Bench Hydraulic Test Center With High Flow Supply
HTC-500-HFS
The Hydraulic Test Center (HTC) is a versatile machine designed to test heavy-duty, off-highway hydraulic components. The 500 hp (373 kW) HTC Complete Bench is for the dealer that services components from a predominately larger machine size mix such as large mining machines and large excavators. The Complete Bench offers full functionality to test all types of pumps and motors including: transmissions, hydraulic motors, hydraulic cylinders, valve blocks, torque converters, open and closed loop pumps.
-
product
CAN & LIN bus Custom Test & Simulation Software
CanX
Schleissheimer Soft- und Hardwareentwicklung GmbH
CanX is the custom testing and simulation software for CAN and LIN bus for specific user groups. The run-time software is designed to execute predefined or automated tasks in testing, work preparation, production, repair or project management.
-
product
21.5" 1920 X 1080 Onboard Passenger Information Display System
ARD-R2150
- EN50155 compliant with cabin temperature OT1 level / EN45545- Brightness: 500 /1500 nits (BOM option)- NXP i.MX8M Plus / Intel Atom x7433RE Processor- Supports 2x M12 D-code LAN 10/100Mb- Wide range DC 24-110V power input- Auto-dimming for enhancing readability and eco-friendliness- IK grade glass/Anti-glare/Anti-reflection/SRF surface coating (optional)- ADLINK PIDS software with EGiFlow for on-site configurations (optional)
-
product
Test Loads
ML12
Each test load provides two test operations for verifying functionality of a Hipot Tester and Ground Continuity Tester. Provides two ground continuity tests (open and short) at up to 35 amperes maximum
-
product
Secondary Injection Relay Test Set
T 1000 PLUS
T1000 PLUS is a protective relay test set especially designed to give the commissioning engineers a multitasking and highly reliable testing equipment.
-
product
Cell Battery Crush Test Equipment (Vertical)
Guangdong Bell Experiment Equipment Co.,Ltd
Cell Battery Crush Test Equipment (Vertical)Application: Single cell crush test (cylinder, pouch, prismatic cell, etc)Crush Tool: Semi-cylinder, hemisphere (According to test standard)
-
product
Communication Systems
Communications systems provide ultimate convenience for all tactical and administrative communication tasks, custom-made for naval vessels of any size – from submarine to destroyer.
-
product
3 Phase Relay Test Set
This is a portable Relay Testing Set suitable for testing different types like over current, earth leakage relays, circuit breakers of 1A – 50A rating etc. All the components are assembled and enclosed with a portable air cooled M.S.cabinet.
-
product
DSP System Design and Vibration Analysis
Bridgenorth has experience in the design and implementation of a broad range of DSP systems. We offer consulting and design services in all aspects of DSP system design. Bridgenorth has worked on projects in the following areas
-
product
CrystalCalHP Calibration System
AMETEK Sensors, Test & Calibration
This portable gauge and transmitter calibration system is 7 to 10 times faster than a deadweight tester. It allows you to do a 10 point up and down calibration in less than 3 minutes including printing out a calibration certificate.
-
product
Advanced Driver Assistance Systems (ADAS) Testing
Advanced Driver Assistance Systems (ADAS) TestingAll modern vehicles are now being equipped with Advanced Driver Assistance Systems (ADAS). The development of such systems requires complex testing, including the ability to control and calculate relative positions between multiple vehicles and objects in real-time. We provide an effective solution for ADAS testing with highly accurate GPS positioning systems to measure relative positions and velocity between multiple vehicles and objects.
-
product
Vision System
Axiomtek's vision system series is designed to focus on vision inspection, guidance, measurement and identification applications. The products have already gone through a complete set of compatibility experiments to eliminate potential integration problems, significantly helping users reduce development and staffing costs as well as accelerate system deployment in factory automation environment.
-
product
Test Drives
Industrial Internet Consortium
Test Drives are short-term, rapid-engagement pilots for technology end users to employ and adopt Industrial Internet of Things (IIoT) technologies. They stimulate IIoT adoption across industry through accelerated implementation. The IIC's neutral collaboration platform fosters partnering to address leading-edge IIoT use cases in 3-6 month projects based upon technology end users' real problems.
-
product
Double-deck High and Low Temperature Environmental Test Chamber
Guangdong Bell Experiment Equipment Co.,Ltd
DGBell’s Double-deck High and Low Temperature chamber was designed to test battery cell combined with charge and discharge equipment, and also available to thermal test for small products and components.
-
product
Low Noise Test Cables For N1413 With B2980 Series, 3m
N1427B
The N1427B is designed to operate specifically with the B2985B/87B Electrometer/High Resistance Meter. It comes with a separate triaxial (special screw-type) female connector and a High Voltage BNC (special type) female connector. This allows terminal configuration to be converted to any other configuration. Therefore, custom test fixture can easily be constructed. The N1413A High Resistance Meter Fixture Adapter is required to connect the N1427B to the B2985B/87B.
-
product
PXE EMI Test Receiver, 1 Hz to 44 GHz
N9048B
Keysight's N9048B PXE is a standards-compliant EMI test receiver equipped with an RF pre-selector and LNA designs. Shorten your overall test time and easily perform gapless signal capture and analysis with real-time scan (RTS) capabilities.
-
product
Attitude Heading Reference System
M&M Modules
PNI’s M&M modules will self adapt and learn its system and its environment automatically to provide accurate quaternions, heading, pitch and roll. All while using 100 times less power than traditional AHRS modules.
-
product
Wireless Crane Systems & Crane Systems
Ningbo Yaheng Electronic Technology Co.,Ltd
YEAHEVER Wireless Crane Systems & Crane Systems
-
product
Kelvin Test Leads
Kelvin Test Probes, Kelvin Test Leads, based on the Parrot™ Clip Invention provide reliable contacts and connections for the Sense and for the Current leads .
-
product
Stackable Single Slot Test Fixture
Stackable Single Slot Test Fixture: Testing, Development, and Validation. The VITA 48.2-compliant Single Slot Test Fixture can be used for development, validation, and environmental testing. It is available in VPX, VME, CompactPCI, or custom form factors and can be vertically or horizontally mounted.
-
product
complete 1/2 inch Type 1 Measurement Microphone System
PS9200KIT
A complete 1/2 inch Type 1 measurement microphone system. Available in 1 Inch and 1/4 Inch versions. The heart of the KIT is the 1/2 inch Type 1 measurement microphone. A selection of 4 different 1/2 inch capsules is offered. These include models with frequency responses to 40 kHz, noise floors of 12 dBA in both free field and pressure versions. Microphone sensitivities range from 12 to 50 mV/Pa.